57
g
WARNING
To reduce the risk of electric shock, fire, explosion, serious injury or death:
Disconnect electric power to the washer before servicing.
Never start the washer with any guards/panels removed.
Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
37989
POSSIBLE CAUSE
TO CORRECT
46. WASHER STOPS IN CYCLE; QUITS AFTER A COUPLE LOADS; IS INTERMITTENT
Belt is tacky and does not allow proper slip.
Check belt and replace if defective.
Belt tension is too great and does not allow
Make sure idler spring is properly connected.
proper slip.
Inoperative timer.
Test timer and replace if inoperative.
Broken, loose, or incorrect wiring.
Refer to appropriate wiring diagram.
Motor overload protector has cycled.
Wait two or three minutes for overload protector to
reset. If protector cycles repeatedly, refer to
paragraph 43.
Motor switch functions inoperative.
Check motor switch and replace if inoperative.
Brake, transmission, or motor have locked
Check that all these components are able to move
up and will not turn.
freely.
POSSIBLE CAUSE
TO CORRECT
47. WASHER IS LOCKED UP OR BINDING
Excessive belt tension.
Replace belt and/or idler spring.
Bind in upper or lower bearing.
Replace bearing.
Bind in water pump.
Replace pump.
Bind in transmission.
Repair or replace transmission.
Brake pads binding.
Free binding pads, or replace pads.
Incorrect voltage.
Contact local utility company, or have a qualified
electrician check power supply.
