19
Basic Troubleshoot
Check if the camera and illuminator are aligned correctly.
For Infra-Red illumination, ensure that a Day and Night or Black and White camera is
used and that the camera switches correctly into night mode.
Check camera and lens. Is iris fully open at night and set correctly. Ensure camera is
fully operational and has correct night time settings and capability.
Ensure correct illuminator lens angle selected for required distance – check stated
performance.
Check the LED status indicator: if green LED indicator is lit on the bottom of the unit,
then the unit is receiving power.
If powering from PoE, ensure Power Sourcing Equipment (PSE) is suitably rated for the
VARIO2 IPPOE HYBRID unit – see page 6 for required ratings – and for all 8 size units
check correct PoE Detection Resistance has been selected – see page 7.
If powering from low voltage 24V DC, check voltage applied and that power supply is
suitably rated for the VARIO2 IPPOE HYBRID unit – see page 6 for required ratings.
Check connection and wiring of CAT5 / 6 cable to VARIO2 IPPOE HYBRID. Verify link
has been established with the router / switch to which the illuminator is connected and
that the wiring is compatible with T-568B wiring standard.
If the illuminators are correctly wired to the network, run the Raytec Discovery Tool and
try to discover the illuminator on the network.
If the illuminator is discovered and the “State” indicator is grey, this indicates that there
is no communications with the illuminator. Ensure IP Address and Subnet Mask of
computer and illuminator are set within the same range. If not, alter IP address of
illuminator or Enable DHCP on illuminator for automatic allocation of suitable IP
address.
Use a Ping command to see if the illuminator and device are on the same network and
have communication.
If still unsuccessful try a different web browser.
If unit still cannot be discovered then type default IP address into browser: 192.168.2.80
If no communication possible after above steps, please contact Raytec for further
support or consider a Hard Reset of the illuminator.
Vario2 IPPOE Hybrid Instruction Guide Rev 1.0.0 Short
