Action
Required
Step1 :
LHS Button
LHS
LED
Step 2 :
RHS Button
RHS
LED
Comment
Disable /
Enable
Manual
Buttons
1 x Long
Push (4s),
then 2 x
short Push
Flashing
Amber
Push to
cycle
Disable /
Enable
Disable – Red
Enable - Green
Buttons will be
Disabled 30
minutes after this
selection is made
– This is to allow
the user to re-
enable manual
buttons if
required
Full Re-set
(including
PIN re-set)
Keep both
buttons
depressed
during
power up –
LEDs will
both flash
Amber
Flashing
Amber
then
solid
green
after
button
release
Keep both
buttons
depressed
during
power up
– LEDs will
both flash
Amber
Flashing Amber
then Flashing
Amber after
button release
Illuminator will
revert to
Programming
Mode, Full
factory default
including No PIN
The illuminator has two modes;
Programming Mode when the remote control can be used and
Operating Mode when most of the remote control functions are disabled.
The
only remote control functions that can be used in Operating mode are;
Enable/Disable Status LEDs, Disable Manual Buttons and PIN entry.
Manual Buttons are always available in programming mode or if they have been
disabled, they can be enabled in programming mode.
Manual Buttons are available in operating mode, provided they have not already
been disabled.
The number of button pushes indicated above are based on the user starting with
the illuminator in either programming or operating mode.
If no buttons are pressed within 2 minutes then the illuminator will automatically
default back into the previous mode it was in – programming or operating mode.
Summary of Contents for VARIO 2 VAR2-i8-3
Page 5: ......
Page 32: ...0DLQ 2IILFH 7 PDLO VDOHV UD OHG FRP ZZZ UD OHG FRP s...
