LED Status Indicators:
Programming Mode and Operating Mode
On first power up (Factory Default) the illuminator automatically enters
Programming Mode. It will then time out automatically after 7 Days to Operating
Mode unless the user actively disables the remote control or uses the manual
buttons in which case Operating Mode will start 30 minutes after the last manual
button press. The LED Indicators feedback the mode you are in. (They are also
used for PIN or Manual Button Control Modes – please see tables / FULL Instruction
Manual)
During Programming Mode and Operating Mode the two LED’s indicate the
following status :
•
LHS SOLID GREEN:
Power Applied
•
LHS FLASHING GREEN:
Remote control IR received problem
•
RHS FLASHING AMBER:
Indicates unit is in programming mode
(Programming Mode Only)
•
RHS SOLID AMBER:
Indicates that a valid command is being received
(Programming Mode Only)
•
LHS FLASHING RED:
Voltage supply problem detected
•
LHS SOLID RED:
Illuminator LED fault detected
All functions of the remote control and buttons are available in Programming
Mode.
The only function of the Remote Control available during Operating Mode is
LED Status Indicators Enable/Disable, entering a PIN or disabling manual buttons
(if done at the same time as disabling the remote – see FULL Instruction Manual
&'
&'
&'
&'
Summary of Contents for VARIO 2 VAR2-i8-3
Page 5: ......
Page 32: ...0DLQ 2IILFH 7 PDLO VDOHV UD OHG FRP ZZZ UD OHG FRP s...
