(+
Manual Setting / Level Indication using RHS Button :
The RHS BUTTON will only have an effect if you have selected a mode
using LHS Button – pressing RHS Button without previously pressing LHS
Button will have no effect on the Illuminator operation – it is used to
control the setting for the mode chosen by LHS Button
When you select a mode using LHS BUTTON, the LHS LED will confirm
which mode you are in and RHS LED will show the current setting / level
of that mode for the Illuminator.
Sequential presses of RHS BUTTON will take you through the available
options to get to the required setting you want within that mode. The
Illuminator will stay at this setting / level providing you do not push the
RHS BUTTON again. Once you have reached the required setting as
shown in the following text, EITHER press the LHS BUTTON to cycle through
the modes until LHS LED extinguishes showing that you are at the end of
the mode loop OR you can also wait 2 minutes for the illuminator to time
out and the value shown by RHS LED will be stored into the illuminator
memory.
The settings programmed will be retained on power recycling unless a
reset has been performed, in which case the factory defaults will be
applied.
Summary of Contents for VARIO 2 VAR2-i8-3
Page 5: ......
Page 32: ...0DLQ 2IILFH 7 PDLO VDOHV UD OHG FRP ZZZ UD OHG FRP s...
