Raytec PULSESTAR VTR6, Installation Manual

Page: 30 / 36

26
Set the Option Flags
REc,p
Where:
c = 1 to select light strobe output
c = 2 to select a trigger output signal
p = 0 to set the P flag (positive triggers)
p = 4 to clear the P flag (negative triggers)
Set Internal Trigger
Enable or disable the internal trigger. When enabled, all outputs are
triggered simultaneously using an internal trigger signal. This setting can be
saved to non-volatile memory using the
AW command.
TT0 Disable internal trigger
TT1 Enable internal trigger (uses previously set period)
TT1,p Enable internal trigger and set the period
Where:
p = period of the triggers in milliseconds
For example:
TT1,200 Set the internal trigger to 200ms (5Hz)
TT1,1S Set the internal trigger to 1 second (1Hz)
Save the settings to memory
AW
The results of the RW , RT , RE ,and TT commands are all saved. Once the
settings are saved to memory they are then retained when the unit is
switched off. If this is not done, changes to the settings are volatile, and if
the unit is switched off they revert to those in force when the last
AW
command was issued.
Clear Configuration
CL
Clears the configuration. The results of the RW , RT , RE , and TT
commands are all cleared.
Report the configuration ST
Reports all the channel settings. Typical output is:
CH 1, MD 1, S 100.0 DL 10us, PU 1.000ms,
RT 1.020ms, IP1,FL0, CS0.000A, RA24V
CH 2, MD 1, S 100.0 DL 10us, PU 1.000ms,
RT 1.020ms, IP1,FL0, CS0.000A, RA36V