Raytec PULSESTAR VTR6, Installation Manual

Page: 5 / 36

1
1
Getting started
Read Section 2, Safety ( or Section 3, Sicherheit, or Section 4, Sécurité) and
Section 10, Reference information, and check the VTR6 fulfils your
requirements.
Mount the VTR6 as described in Section 5, Mounting the VTR6. Connect the
VTR6 up to a supply as described in Section 6, Connections. Set up the VTR6 for
the desired operation as described in Section 10, Configuration commands.
Visit www.rayteccctv.com for application notes on this product. There is also a
Support page which has information on troubleshooting problems.
1.1
Summary of features
Throughout this manual, references to the VTR6 refer to all variants in the VTR6
range unless otherwise stated. The convention for the product number is:
The convention for standard VTR6 product numbers is:
VTR6-www-aa-ccc-NC
Where:
www is the wavelength of light in nanometres; 850 , 940 or cool white W
aa
is the optical beam profile in degrees:
12
,
28 or 50
for
white,
14, 28 or 50
for 850nm or 940nm.
ccc
is the communications protocol; ETH or RS232
NC
No cable. If a cable is required, it should be ordered
separately.
The convention for special variants VTR6 part numbers is as above with the
addition of a specific suffix:
VTR4-www-aa-ccc-NC-Txx
Txx
is the variant number; -T54 for example. This field is not
required when specifying standard products