1
Antenna (supplied with
the hub)
2
Nut
3
M3x10 fixing screws x 3
4
Mounting plate
5
Mounting surface (14 mm
(0.55 in) diameter hole
required)
6
5 m (16.4 ft) antenna extension cable
7
Split washer
8
Wireless hub
1. Check the selected location for the Mounting plate, a clear flat area is required.
2. Using a pencil, offer up the Mounting plate to the desired location and mark the location of the
screw holes and the center hole on the mounting panel.
3. Drill holes for the mounting fixings using a drill with a suitable sized drill bit.
4. Drill the center hole using a 14 mm (0.55 in) drill/hole cutter.
5. Pull the connector end with the exposed thread through the center hole.
6. Place the mounting plate over the end of the connector.
7. Place the split washer and nut over the end of the connector and secure by hand tightening
the nut.
8. Secure the mounting plate to the mounting surface using the supplied screws.
9. Screw the antenna supplied with your hub to the connector.
10. Connect the opposite end of the extension cable to the antenna connector located on the top
of the wireless hub.
Mounting the charging holster for the wireless handset
Before mounting, ensure that:
• Your selected location meets the location requirements found in this document.
• You pay particular attention to the wireless location requirements.
• The product operates correctly at the desired location before mounting.
• The product does not interfere with nearby devices.
1. Using the supplied mounting template mark the location of the mounting holes and if required,
the cable hole.
45
