Raymarine Evolution EV-1, Installation Instructions Manual

Page: 53 / 142

4. Insert the relevant wires from the SeaTalk ng spur cable into the SeaTalk ng screw terminals, as
shown in the illustration above. Tighten the screws to secure the wires. Repeat for all required
connections.
5. Push the screw terminals back into the connector panel, ensuring a tight connection.
6. Route the cables through the cable guides located on the lower lip of the unit. Raymarine
recommends that you use cable ties to secure the cables to the unit.
7. Once all connections are made and the cables correctly routed in the guides, replace the ACU
cover, ensuring a tight fit between the cover’s rubber seal and the cables.
8. Using the supplied screws, secure the cover to the unit, ensuring that the clips are aligned and
secured (along with an audible click):
Installation 53