• The product is supplied from a separate battery from
that used for engine start. This is important to prevent
erratic behavior and data loss which can occur if the
engine start does not have a separate battery.
• Raymarine specified cables are used.
• Cables are not cut or extended, unless doing so is
detailed in the installation manual.
Note: Where constraints on the installation
prevent any of the above recommendations
,
always ensure the maximum possible separation
between different items of electrical equipment, to
provide the best conditions for EMC performance
throughout the installation
RF exposure
This transmitter with its antenna is designed to comply
with FCC / IC RF exposure limits for general population
/ uncontrolled exposure. The WiFi / Bluetooth antenna
is mounted behind the front facia on the left hand side
of the screen. It is recommended to maintain a safe
distance of at least 1 cm from the left hand side of the
screen.
FCC
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1.
This device may not cause harmful interference.
2.
This device must accept any interference received,
including interference that may cause undesired
operation.
FCC Interference Statement (Part 15.105 (b))
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one of the following
measures:
1.
Reorient or relocate the receiving antenna.
2.
Increase the separation between the equipment
and receiver.
3.
Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
4.
Consult the dealer or an experienced radio / TV
technician for help.
Industry Canada
This device complies with Industry Canada
License-exempt RSS standard(s).
Operation is subject to the following two conditions:
1.
This device may not cause interference; and
2.
This device must accept any interference, including
interference that may cause undesired operation
of the device.
This Class B digital apparatus complies with Canadian
ICES-003.
Industry Canada (Français)
Cet appareil est conforme aux normes d’exemption de
licence RSS d’Industry Canada.
Son fonctionnement est soumis aux deux conditions
suivantes:
1.
cet appareil ne doit pas causer d’interférence, et
2.
cet appareil doit accepter toute interférence,
notamment les interférences qui peuvent affecter
son fonctionnement.
Cet appareil numérique de la classe B est conforme à
la norme NMB-003 du Canada.
Suppression ferrites
Raymarine cables may be fitted with suppression
ferrites. These are important for correct EMC
performance. If a ferrite has to be removed for any
purpose (e.g. installation or maintenance), it must be
replaced in the original position before the product is
used.
Use only ferrites of the correct type, supplied by
Raymarine authorized dealers.
Connections to other equipment
Requirement for ferrites on non-Raymarine cables
If your Raymarine equipment is to be connected to other
equipment using a cable not supplied by Raymarine, a
suppression ferrite MUST always be attached to the
cable near the Raymarine unit.
Declaration of conformity
Raymarine Ltd. declares that this product is compliant
with the essential requirements of EMC directive
2004/108/EC.
The original Declaration of Conformity certificate
may be viewed on the relevant product page at
www.raymarine.com
.
Product disposal
Dispose of this product in accordance with the WEEE
Directive.
The Waste Electrical and Electronic Equipment
(WEEE) Directive requires the recycling of waste
electrical and electronic equipment. Whilst the WEEE
Directive does not apply to some Raymarine products,
we support its policy and ask you to be aware of how
to dispose of this product.
Pixel defect policy
In common with all TFT units, the screen may exhibit
a few wrongly-illuminated (“dead”) pixels. These may
appear as black pixels in a light area of the screen or as
colored pixels in black areas.
If your display exhibits MORE than the number of
wrongly-illuminated pixels stated below, please contact
your local Raymarine service center for further advice.
5
