0049-1800-xxx 326X V.34, V.34-SDC and V.32bis Series Modem – USER’S GUIDE 02/23/2010
Rev. A
Page 76
of
205
correction link handshake takes place after the modulation mode handshake, and before DCD (if DCD
is not configured for the High setting) transitions from off to on.
This command causes the modem to answer a call regardless of the contents of S-Register 0 (Ring
Count to Answer On).
If the ATA command is issued while the modem is in escape mode or in remote configuration, the
modem responds with:
ATD, Dial
To dial directly from the keyboard, enter ATD followed by the number you want to dial. For example:
The ATD command causes the modem to go off-hook, dial the number, and execute all dial modifiers
in the dial string. The type of call progress message you see is controlled by the
Call Progress
(ATX)
setting. The modem can dial up to 50 characters, including spaces.
In originate mode, if the ATD command is issued without a phone number, the modem goes off-hook.
If ATD is issued while the modem is in escape mode or remote configuration, the modem responds
with:
NOTE:
Any invalid characters inserted into the dial string will be ignored.
ATH, Hang Up
You may hang up the modem after entering the online escape mode by typing ATH or ATH0. Typing
ATH1 while in command mode causes the modem to Busy Out until either the ATH command is
entered or the
key is pressed.
NOTE:
For busy out, make certain that the TELCO OPT’S Telco
option is set for RJ4MB.
ATI, Display Software Information
