55
Menu
Level 1
Menu
Level 2
Menu
Level 3
Menu
Level 4
Menu
Level 5
Menu Level
6
Default
Selection
Comment
d
New password
programming password.
Confirm new password
Maintena
nce
User cannot access
Not accessible to user.
Factory
RESET
Cancel
Cancel
Resets the system to factory
default settings.
Confirm
Auto
Test
Only applicable in Italy
Only applicable in Italy.
CT self-
check
Cut off all load then comfirm
This action must be
performed when the inverter
is externally connected to the
CT.
Before the CT self-check, the
inverter needs to be
connected to the power grid
and the battery. The backup
circuit breaker and normal
load breaker needs to be
disconnected. The CT self-
check takes about 1~5
minutes.
Inquire
INV Module
Shows the user what model
of inverter is in use.
Module SN
Shows the user the serial
number of the inverter.
Firmware
Shows the user the firmware
version.
Record
Shows the user the active
faults or errors.
BMS Info
Shows the user the battery
modules connected and
connection state.
Statistic
Time stat
Run:
Shows the user the hours run
of Inverter and Grid
connection.
Grid:
Summary of Contents for RI-ENERGYFLOW-3P-MODULAR...
