RG55R Operation • Service • Maintenance
800.392.2686
41
Engine Oil Level
To access the engine oil fill cap and dipstick (1), remove the
cover on top of the engine enclosure near the radiator cap.
The engine oil cap (2) will be available after the cover is
removed from the top of the engine enclosure.
Place a container to catch the used oil underneath the
bottom of the oil pan.
Loosen the plug (3) to drain the oil is located as shown. Be
sure to tighten the fitting securely back ontot the oil pan
before filling engine with new oil.
Engine Oil Filter -
Remove the oil filter (4) with a filter wrench. When installing
a new filter, apply a slight coat of oil onto the gasket of the
new filter. Screw the new filter in by hand. Do not overtighten
the filter, this could cause deformation of the rubber gasket.
After the new filter has been successfully installed and
ensured that there are not any leaks. Check the oil level on
the dipstick, fill oil to the specified level.
More information and instructions can be found in your Kubota
Engine Operator Manual.
Maintenance
NOTICE
Check only when the engine is in a level position.
1
2
3
NOTICE
Use the proper SAE engine oil according to ambient
temperatures.
NOTICE
If using an oil from a different maker, or different
viscosity is needed, be sure to drain old oil
completely. Do Not mix two different types of oil.
BE SURE TO SHUT DOWN THE MACHINE, AND
ENGINE BEFORE CHANGING ENGINE OIL
AND/OR FILTER.
4
Summary of Contents for RG55R
Page 27: ...RG55R Operation Service Maintenance 800 392 2686 27 Operation...
Page 58: ...RG55R Operation Service Maintenance 58 Hydraulic Schematic 805921...
Page 59: ...RG55R Operation Service Maintenance 800 392 2686 59 Hydraulic Schematic 805921...
Page 67: ...RG55R Operation Service Maintenance 800 392 2686 67 Specifications...
