www.raycap.com
©Raycap • All rights reserved
320-1261 Rev.C
Page 5 of 24
INSTALL INSTRUCTIONS
3315-ALM-RS485
Pre-wiring Preparation Procedure
4.1
Ensure the lanyard from enclosure lid to
enclosure base is secure.
Note:
Use metal mounting frame to
secure hoist when lifting to tower top.
Warning:
Holes in lid for lanyard and
padlock must NOT be used as hoist
locations.
4.2
WARNING –
Disconnect or disable the
DC power source to the product prior to
beginning this installation.
(Installed cables and wires not shown for clarity)
4.3
Open up clamps on all sides of the
enclosure cabinet by lifting the hinged
clamp tabs.
4.4
Carefully slide the copper dome over the top
of the assembly and set aside.
4.5
To access power, fiber and alarm wire
connections, unclasp 1/4 turn latches,
then fold down fiber tray.
