www.raycap.com
©Raycap • All rights reserved
320-1261 Rev.C
Page 3 of 24
INSTALL INSTRUCTIONS
3315-ALM-RS485
Contents
1 Copyright
3
1.1 Disclaimer
3
1.2 Warnings
4
2 Introduction
4
3.1 Prerequisites
4
3.2
Required Tools
4
3.3
Kit Contents
4
4.1
Pre-wiring Preperation Procedure
5
6.1
Removing Strikesorb Modules
7
7.1
Removal of Touch Guard
8
8.1
Removal of Existing Alarm Wiring
9
9.1
Removal of Stand-Offs & Alarm Board
10
10.1
Installation of 3315-ALM-RS485
11
11.1
Installing Alarm Wiring
14
13.1
Installing Complete
21
14.
Supported Configurations
22
1.0
Copyright
©
Raycap, Inc. 2018 - All Rights Reserved
1.1
Disclaimer
The information in this document is subject to change without notice and describes only the product
defined in the introduction of this documentation. This documentation is intended for the use of
Raycap customers only for the purposes of the agreement under which the document is submitted,
and no part may be used, reproduced, modified or transmitted in any form or means without the prior
written permission of Raycap. The documentation has been prepared to be used by professional
and properly trained personnel, and the customer assumes full responsibility when using it. Raycap
welcomes customer comments as part of the process of continuous development and improvement
of the documentation.
This product is suitable for OSP.
Raycap has made all reasonable efforts to ensure that the instructions contained in this document
are adequate and free of material errors and omissions. Raycap will, if deemed necessary, explain
issues which may not be covered by this document.
The contents of this document are subject to revision without notice due to continued progress in
methodology, design and manufacturing. Raycap shall have no liability for any error damage of any
kind resulting from the use of this document.
