57
Raveon Technologies Corp.
If
Output Data Framing
is enabled, any other Carrier Detect and flow control
output configuration is ignored.
11.6. RF Power Output
The ATPO command sets the RF power output. The setting is 0-100.
ATPO 0 disables the transmit RF power output. Setting ATPO to 100 puts the RF
power output at 100% power output. The actual RF power output at 100% is the full
RF power for the board. This may vary by model number. See the data sheet for
maximum RF power levels for various models. For a 2W RV-M6S radio modem,
typical RF power levels are shown below. When setting the RF power below 100%,
connect the M6 to a calibrated what meter and measure the power and adjust ATPO
to set it to the desired power level.
RF power output in watts.
ATPO:
100
80
60
50
40
20
10
5
1
VB
2.0
1.6
1.2
1
0.9
0.4
0.2
0.1
0.07
VA
2.0
1.6
1.2
1
0.9
0.4
0.2
0.1
0.07
UC
2.0
1.6
1.2
1
0.9
0.4
0.2
0.1
0.07
