SBGuidance Auto I Rev. A I CAN
Page38/52 I SBG-Auto CAN-EN-Rev. A
6.1
Mounting the standard GPS antenna
bracket
Figure 41 shows an example of the structure of
standard GPS antenna equipment, which consists of a
standard GPS antenna bracket, a GPS dummy and an
UNC bolt + nut. The standard GPS antenna bracket can
be taped to the cab roof using double-sided adhesive
tape.
The following guidelines must be observed when
installing the GPS antenna:
The GPS antenna must be mounted at least 60
cm in front of the rear axle.
Mount the GPS antenna in the centre of the
tractor.
Mount the GPS antenna using the UNC bolt
included.
Fasten the TNC-dummy to the GPS antenna
bracket.
Wire the antenna cable connector with the
largest connector through to the inside of the
cabin.
Fasten the antenna cable so that it cannot
become pinched anywhere and conceal inside
the cabin upholstery, together with the GPS
patch antenna cable, radio antenna cable or
UMTS antenna cable.
Mount the antenna cable in such a way that no
water is allowed to flow along the cable into
the cabin.
Label the antenna cable inside the cabin with
label ‘GPS1’.
Figure 41 Standard GPS-antenna bracket with UNC
nut and bolt and TNC-dummy.
Summary of Contents for SBGuidance Auto
