CHAPTER
5
RCM - Sprayer Mounting and Connection: Mounting Plate Preparation
31
CHAPTER 5
RCM - SPRAYER MOUNTING
AND CONNECTION
MOUNTING PLATE PREPARATION
NOTE:
If Raven Autoboom XRT is already installed on this machine, skip this section and refer to “Mount the
RCM - Sprayer with Raven Autoboom XRT” on page 33.
1. Locate the electrical panel on top of the center rack on the back of the machine and above the section valves.
NOTE:
For older machines, loosen the two bolts that secure the electrical box hood in place, and lift the
cover off of the electrical box to find the electrical mounting plate.
FIGURE 1. Electrical Panel Location
2. Locate the existing product controller ECU.
3. Remove the bolts that secure the existing product controller ECU to the mounting plate.
4. Remove the existing product controller ECU and disconnect the harness. The product controller ECU will not be
used and can be set aside.
5. For older machines, remove the three bolts that secure the Ultraglide node to the mounting plate.
6. Mount the Ultraglide node to the available mounting location on the left side of the mounting plate.
Summary of Contents for RCM-Sprayer Hawkeye 2
