Raven MPV-7100, Service Manual

Page: 17 / 50

Contactor Cover and L-Shaped Bracket
Instructions
Tools:
Parts:
• none
•
•
•
Impact Drill
8mm Wrench
8mm Socket
Removing Contactor Cover and L-
Shaped Bracket
IMPORTANT: Turn off power & remove key.
1. Locate the contactor cover and L-shaped bracket on
the right side (if seated in the driver’s seat) of the MPV
(see Figure A).
Remove 3 screws using the impact drill and 8mm
socket (see Figure B).
Remove the last screw (bottom, right hand corner)
using the 8mm wrench (see Figure C) - the close
location of the tire prevents the use of the impact drill.
When finished, four screws should be removed and
the contactor cover & L-shaped bracket can now be
removed.
2.
3.
Installing Contactor Cover and L-
Shaped Bracket
IMPORTANT: Turn off power & remove key.
Top Screw
1. Hold the contactor cover in place with one hand while
tightening the top screw on the right using the impact
drill and 8mm socket. Use the 8mm wrench to tighten
the bottom screw on the right - total of 2 screws
installed (see Figure D).
2. Install the L-shaped bracket - with lip to the outside -
(see Figure E) using the impact drill and 8mm socket
on the top and bottom screws - total of 2 screws
installed (see Figure F).
3. See Figure G for fully installed contactor cover and L-
shaped bracket.
D e n v e r G l ob a l P r o duc t s 1 000 E as t P o we ll D r. | Li nc ol nt o n , N C 2 80 9 2 U. S . A
© 2 0 1 3 D en v e r Gl o b a l P ro du c t s | RATO A ll r i gh t s r es e rv e d .
L-Shaped Bracket WITH LIP
ON THE OUTSIDE
Contactor Cover
G
L-Shaped Bracket
WITH LIP TO THE
OUTSIDE
Bottom Screw
Impact Drill with
8mm Socket
F
L-Shaped Bracket
WITH LIP TO THE
OUTSIDE
E
Top Screw on the
Right
Bottom Screw
on the Right
D
8mm Wrench
Last Screw -
Remove Using the
8mm Wrench
C
3 Screws - Remove
Using Impact Drill
B
L-Shaped
Contactor
Bracket
Cover
A