8
4.
MOUNTING LIQUID AND GRANULAR CONTROL VALVES
The mounting of the liquid and granular Control Valves are based on the type of
pre-wet and hydraulic system of the truck.
5.
MOUNTING CONSOLE AND CABLING
NOTE: For instructions on mounting custom cabling, hydraulic valves, and
liquid control systems, consult your dealer.
l)
Mount the Console to a secure support inside the cab of the vehicle without
hindering the visibility of the operator.
2)
Connect the Console Control Cable to the plugs in the back of the Console. (See
Figure 7
).
FIGURE 7
3)
Turn POWER switch to OFF and route the Red wire to the +12 volt fuse block and
White wire to the negative connection. (DO NOT CONNECT WIRES TO THE STARTER).
Secure the wires with plastic cable ties.
4)
Connect the Speed Sensor Cable to the plug in the back of the Console.
5)
Verify connector "A" has plug installed and "B" is connected to "C".
Summary of Contents for DCS 700
Page 1: ...DCS 700 INSTALLATION AND SERVICE MANUAL ...
Page 3: ......
Page 4: ...Manual Rev B DCS 700 063 0171 711 7 99 016 0159 775 ...
Page 61: ...NOTES ...
