USER MANUAL
– Safecheck
4
0
max 40°C
105°F
min -10°C
15°F
0
1.
Introduction
This manual describes the installation and use of the Safecheck. The Safecheck is a hydraulic measuring
system for forklift trucks and stackers. The installer must be informed of the contents of this manual.
Follow the contents of the manual precisely. This manual should be kept on a safe and dry place. In case
of damage or loss the user may request a new copy of the manual from RAVAS.
2.
Warnings & Safety measures
When installing the Safecheck please observe the instructions and
guidelines in this manual carefully. Always perform each step in sequence.
If any of the instructions are not clear, please contact RAVAS.
-
All safety regulations that apply on the truck remain valid and unchanged;
-
No weighing operations are allowed if any persons or objects are in the vicinity; around, under or
close to the load;
-
Any modifications done to the system must be approved in writing from the supplier, prior to any
work being completed;
-
It is the sole responsibility of the purchaser to train their own employees in the proper use and
maintenance of this equipment;
-
Do not operate this unit unless you have been fully trained of its capabilities;
-
Check the accuracy of the scale on a regular basis to prevent faulty readings;
-
Only trained and authorized personnel are allowed to service the scale;
-
Always follow the operating, maintenance and repair instructions of this truck and ask the supplier
when in doubt;
-
RAVAS is not responsible for errors that occur due to incorrect weightings or inaccurate scales;
-
A weighing is performed by slowly lowering the forks, this movement can be stopped at any time
by pressing the on/off button on the indicator.
.
Should you have any further questions after reading this manual, please contact us at:
RAVAS EUROPE B.V.
Toepadweg 7
Postbus 2023
5300 CA Zaltbommel
Nederland
Phone: +31 (0)418-515220
Fax: +31 (0)418-515320
Internet: www.ravas.com
Email:
IP65
READ
CAREFULLY
