Stand 25.05.2011
Seite 28
Operating instruction TAXON
Page 28
of 42
Bucher Municipal Wernberg GmbH
Daimlerstr. 18
92533 Wernberg-Köblitz, Germany
Tel.: +49 (9604) 93267 - 0
Fax.: +49 (9604) 93267 - 49
E-Mail: [email protected]
Internet: www.buchermunicipal.com
• Attention must be paid when working on the stainless steel spreader that no steel tools or steel screw
connections are used (Use stainless steel screws!).
• Also, no steel parts must be welded or screwed on.
• In addition, there must be no direct contact with steel parts, e.g. loading bridge.
• Plastic or rubber plates must always be used as intermediate layer.
• If work with an angle grinder is necessary, use a new disk, as the steel particles could possibly cause
corrosion.
The cleaning and care agents listed below must used absolutely separate!
Inox Clean (Cleaner), Inox Protect (Protective agent), Chromol (Care agent), Antox 71E (Pickling agent).
The safety instructions of the respective manufacturer must hereby be observed.
• Observing this care instruction is the precondition for possible guarantee or warranty claims
against corrosion and rusting through!
• Therefore, a visual inspection must be carried out rather often!
• Flash rust deposits must be removed immediately.
• Thorough cleaning and care must be carried out once a year after the spreading season.
• In case of infringements no guarantee or warranty claims will be accepted!
No guarantee claim is accepted in case of damage or injury to the surface from external infl uence!
5.6 Electrical
system
The electrical system of the spreader is largely free from maintenance.
If not used for a longer period of time, the plug-in connections in the cable harness separation should be
lightly greased with acid-free grease (Vaseline).
•
Do not use contact spray or similar lubricating agents!
•
Pay attention, in case of disassembled spreader, that the plug and the socket of the cable harness are
closed clean with the respective seal caps!
•
Check the cable harness separation and the distribution box at regular intervals for moisture!
•
Take the control panel out of the driver’s cabin after the spreading season and store it in a dry place
protected from sun irradiation!
•
Install the connection cables in the driver’s cabin in such a way that they cannot be crushed or
damaged in some other way!
