Boundary spreading for working widths of 20 - 24 m
For an optimal spreading pattern, it is recommended that the material output quantity be reduced
by
30
%
on the boundary spreading side.
In the case of spreaders with an “M” slide actuator in conjunction with an external remote control,
no one-sided volume reduction is possible.
•
Reduce the volume on both sides by 30%
n
Instructions for spreading with the TELIMAT unit
You set the intended TELIMAT position from the tractor via a single-acting control valve.
•
Boundary spreading: lower position
•
Normal spreading: upper position
NOTICE!
Spreading errors caused by the TELIMAT unit not reaching its end position
If the TELIMAT unit is not completely at its end position, spreading errors may occur.
u
Make sure that the unit is always in the specified end position.
u
When switching from boundary spreading to normal spreading, operate the control valve until
the unit is
completely
located in the top end position.
u
For longer boundary spreading (depending on the condition of your spreading unit), operate
the control valve in regular intervals and return the unit to the end position.
When older control equipment is used, leaks are possible during boundary spreading. The
TELIMAT unit can leave the reached end position (lower position) again. In order to avoid
spreading errors, return the unit to its end position at regular intervals.
9.11
Spreading on the headland with TELIMAT T1 special equipment
In order to achieve good fertilizer distribution in headlands, a precise arrangement of the tracks is
essential.
9. Spreading operation
MDS 8.2/14.2/18.2/20.2
5902916
99
Summary of Contents for MDS 8.2
Page 150: ......
