Ratio io5, Installation Manual, Page: 33 / 46

Comissioning | 33
+44 (0) 1527 396900 / info@ratioev.uk / www.ratioev.uk
Power sharing
Configuration
Configure the following settings for the charger.
If you have a single charger, leave this option Disabled.
If you have multiple chargers interconnected with data cables,
activate Power Sharing.
Set the charger that is directly connected to the Sensor Box to:
Main.
Available options: Main, Sub 1, Sub 2, Sub 3, Disabled.
To enter the Advanced settings menu, select the charger, tap the gear icon at the bottom
right corner, and select Advanced settings.
Single phase
Home connection
maximum current
Three phase
Set this value to the size of the grid connection as measured by the
CT clamps. e.g. if the premises has a 1 x 100A connection, set this
value to 100A. This value is used for
Dynamic Load Balancing
.
Set this value to the size of the grid connection as measured by the
CT clamps. e.g. if the premises has a 3 x 32A connection, set this value
to 32A. This value is used for
Dynamic Load Balancing .
Note: Make sure every sub charger is set to a unique SUB number.
Note: Make sure only one of the interconnected chargers is set to “Main Controller”.
Note: PureSolar mode is not compatible with Power Sharing . If you enable Power Sharing ,
the charge mode will be set to io5.
Note: Entering the Advanced settings menu is only possible if you are within Bluetooth®
range of the charger.
Note: It is not possible to enter the settings menu during a charging session.
Charger connection
maximum current
Set the maximum allowed charging current of the charger.
Range: 6A – 32A.
Note: This value must be lower than the rating of the used circuit protection device. i.e,
MCB/RCBO.