Ratio io5, Installation Manual, Page: 20 / 46

Installation | 20
+44 (0) 1527 396900 / info@ratioev.uk / www.ratioev.uk
3. Mark the locations of the holes in the charger housing on the wall.
4. Carefully remove the charger and lay it on a flat, stable and dry surface.
5. Drill the holes in the wall. Use an appropriate drill and drill bit.
6. Insert rawl plugs (not included) if applicable.
7. Align the charger with the holes in the wall and secure it with four 5 x 35mm screws (not
included).
1. Remove the five Torx screws from the housing lid. Use a size T15 screwdriver.
2. Move the housing lid to the side to access the inner circuitry of the product.
5.5. Connect the power cable to the charger
20
Ratio io5 Charger Manual
3 . Mark the locations of the holes in the charger housing on the wall.
4 . Carefully remove the charger and lay it on a flat, stable and dry surface.
5 . Drill the holes in the wall. Use an appropriate drill and drill bit.
6 . Insert wall plugs, if applicable.
7 . Align the charger with the holes in the wall and secure it with four 5×35 mm screws (not
included).
5 . 4 . Connect the power cable to the charger
TX10
1 . Remove the five Torx screws from the housing lid. Use a size TX10 screwdriver.
2 . Move the housing lid to the side to access the inner circuitry of the product.
20
Ratio io5 Charger Manual
3 . Mark the locations of the holes in the charger housing on the wall.
4 . Carefully remove the charger and lay it on a flat, stable and dry surface.
5 . Drill the holes in the wall. Use an appropriate drill and drill bit.
6 . Insert wall plugs, if applicable.
7 . Align the charger with the holes in the wall and secure it with four 5×35 mm screws (not
included).
5 . 4 . Connect the power cable to the charger
TX10
1 . Remove the five Torx screws from the housing lid. Use a size TX10 screwdriver.
2 . Move the housing lid to the side to access the inner circuitry of the product.
T15