15
Pair the CC Transmitter to your iX3M
After powering up the CC transmitter, go on TRANSMIT menu on your iX3M (by pressing the first button from the left from
the watch mode and wipping the menu entries).
Place the iX3M about 20-30cm from the CC Transmitter (Attention: If you place the
CC Transmitter to close to the iX3M the pairing procedure may not work properly).
Press C to start the search of the CC Transmitter (SRC).
As soon as the Pair is done, the TX ID of the CC Transmitter will be displayed.
(Each CC Trasnmitter has 31 TX ID channels, the TX ID is randomly assigned in order to avoid interferences with
other CC Transmitters. To change the TX ID of your CC Transmitter see the dedicated chapter on this manual).
In order to check the correct pair of the CC Trasnsmitter activate the dive mode in
your iDive. Within about 30 sec. the tank pressure will be displayed in the bottom-
right corner of the display (BAR)
(RBT will be displayed only during the dive. See dedicated chapter on this manual)
After the first pair your iX3M and your CC Transmitter will connect automatically
(the iX3M have to be in dive mode).
Attention: Using the CC Transmitter will reduce the autonomy of your iX3M of about
-15%. Set the TX ID on “OFF” in you are not using a CC Transmitter.
20-30cm
TRANSMITTER
TX TANK ID:
TANK RESERVE:
B
A
C
D
EXIT
NEXT
ENTRY
SRC
OFF
30
RESET
0
.0m
00
:00
21%
---
---
MIX
OC
BuL
BAR
RBT