ALL APPLICATIONS (VENTED and VENT FREE OPERATION)
Log Placement (cont.)
Pilot
Burner
Pilot
Ember
Lifter
REAR LOG
Rear Bracket
C 7
Pilot
Ember
Lifter
Burner
FRONT LOG (1)
FRONT LOG (2)
D F C 7
Pilot
EMBER MATERIAL: With the FRONT and REAR
LOGS on the Grate as shown, pull apart the E M B E R
MATERIAL into long loose, thin pieces and drape
them over the EMBER LIFTER. The pieces should
be no more than one to two pieces of ember
material in depth. To enhance ember performance,
after approximately 5 minutes of burn time, gently loosen
and lift EMBER MATERIAL.
NOTE: Thinner, less densely packed Ember Material
pieces enhance the overall glowing ember effect. The
looser the pieces, the better the glowing ember effect!
.
Pilot
Burner
Pilot
Position
Ember Material Recomended Actual Size
Ember
Lifter
Burner
WARNING: Excessive amounts of Ember Material or Ember Material which is too tightly packed can result in
decreased combustion performance and elevated levels of carbon monoxide.
.
Top Logs:
1. LEFT & RIGHT TOP LOGS: Place L E F T and
RIGHT TOP LOGS over Left and Right Pins on
REAR LOG (C7) or the two FRONT LOGS
(DFC7). Position as shown
2. CENTER LOG: Using the log locator hole and pin,
place the CENTER LOG onto the CENTER PIN of
REAR LOG (C7) or on the two FRONT LOG
pins (DFC7).
WARNING: Failure to position parts in
accordance with these diagrams or failure to
use only parts specifically approved with this
heater may result in property damage or
personal injury.
Volcanic Ash Placement:
Place VOLCANIC ASH
only on the firebox floor. NEVER PLACE VOLCANIC
Center Log
Left Top Log
Right Top Log
"Char Effect"
Pins
"Char Effect"
Pilot
Burner
Pilot
Burner
Pins
Pins
C 7
D F C 7
ASH (or any material other than the EMBER MATERIAL provided) ON TOP OF BURNER!
LIGHTING and OPERATION
Control Locations and Description
Manual Models (C7-M or DFC7-M)
•
Valve Knob (Manual Control): Pilot Lighting,
Burner Selection (NORMAL-20,000 Btu or BOOST-
30000 Btu). (Figures 5 and 6).
Switch Models (C7-S or DFC7-S)
•
Primary Gas Valve Control Knob (Switch
Models): Pilot Lighting and Valve gas output
adjustment from OFF to FULL. See Figure 8.
•
3 Way Selector Switch: Mode selections:
SWITCH ON, OFF or REMOTE ACCESS ON. Fig 7.
All Models
•
Piezo Ignitor Button: Pilot Flame Ignition.
Figure 5
3 WAY SELECTOR SWITCH
(Switch Models Only)
PIEZO IGNITER
BUTTON
PRIMARY GAS VALVE
CONTROL KNOB
(Switch Models Only)
VALVE KNOB (Manual Model): Two settings-
Normal (20,000 Bu) or Boost (33000 Btu).
7
