50
Rasilient Confidential
- Use or disclosure of data contained on this page is
subject to the restriction on the title page of this document.
2.3
Cabling and Access to electricity
After the equipment has been installed, please check again that the equipment has been fixed safely.
After the check, connect AC power and SAS cables to the PS5012HD.
For safety reasons, it is recommended that the equipment should be installed as the flow chart below
shows.
Figure 2-34 Flow chart
Pull out Chassis from Rack:
see section 2.2.6.1.
Push Chassis into Rack:
see section 2.2.8.
2.3.1
Connecting the power cords
1)
Connect the system’s power cords to the rear side of system.
2)
Connect power cord to the power source.
Figure 2-35 Connecting the Power cords
NOTE
: Turn on your enclosure, check all the LEDs are lighting normally and there are no fault conditions.
