6
2.2
MTS Multi-Magnet CANbus sensor requirements
MTS Multi-Magnet sensors that are used with the TDD2 should be ordered with the correct
number of magnets so that the factory sets the magnets parameter correctly. For all TDD2’s with
software dated before Feb 18
th
of 2006 the sensor must be programmed at the factory with a
Position ID of 100 and the number of magnets set to the desired value and at least 3. The serial
number must be entered correctly.
For TDD2’s with software dated Feb 18
2006 or later, the TDD2 will automatically work with any
node id and position id and will reprogram the number of magnets parameter if it is less than the
desired value (Set in the ‘AGNETS' parameter in the ‘TSNDCR’ menu section) At power on the
TDD2 scans all node id’s from 0 to 100 to find the sensor. The serial number parameter is not
required unless the node id is not with the range of 0 to 100
