Ransomes MT503, Safety, Operation & Maintenance Manual/Parts List

Page: 98 / 132

en-98
8 MAINTENANCE AND LUBRICATION
8.19.1 STEERING ROD AND STEERING LINK CHECK _________________________
1. With the steering in a straight position and the Alignment Tools still fitted (after the Wheel Alignment
procedure) inspect the “free movement” of the steering linkage can be checked to see if it is within
specification.
2. With the Alignment Tools secured with the wheel nuts, pull and push the alignment tool, making sure not to
apply too much force so as not to extend or retract the Hydraulic Steering Cylinder.
3. Using Fig 1 check the “free movement” does not exceed a combined movement of 3 mm for A & C or
B & D.
4. If excessive movement is noted, carefully inspect where the movement is originating from; either the Rod
Ends or the Steering Link.
5. Replace only components that are noted to experience “free movement” greater than 3mm.
6. Replace the rear wheels and wheel nuts.
7. Remove the axle stands and lower the machine to the floor.
8. Tighten the wheel nuts and torque to 75 Nm (55 ft-lbf).
FRONT
REAR
A B
C
D
Figure 1 - Steering Link Test Movement