Ransomes MT503, Safety, Operation & Maintenance Manual/Parts List

Page: 117 / 132

en-117
QUALITY OF CUT 12
12.2 STEP CUTTING__________________________________________________
NOTE: Arrow indicates direction of travel.
“Step cutting” occurs when the grass is cut higher
on one side. The cause is mechanical wear or
incorrect setting of the roller or deck caster.
Possible Cause Correction
The HOC (height-of-cut) settings are different between
units or not set even on individual Units
Check HOC adjustment of cutting units. (See
section 9.6.)
Worn roller bearings. Check and replace the roller bearings.
Changes in turf density Change the direction of cut.
The machine ride height is uneven side to side. Check and adjust the tyre pressure. (See section
4.3.)
General wear and tear of the machine. Check machine for any damaged or worn parts.
Seized or damaged cutting unit pivot pin. Grease pivot housing. Inspect and replace bent or
damaged pivot pins.
TN0221