en-81
MAINTENANCE AND LUBRICATION 8
8.2.1 ENGINE LUBRICATION _____________________________________________
Check Engine Oil Level
Check the engine oil level before you start or at least five minutes after you
stop the engine.
(a)
Park the machine on level ground, remove the dipstick (A), clean
with a cloth and replace in position.
(b)
Remove the dipstick (A) again and check the oil level. The oil must
be between the two level indicators (B) on the dipstick.
Change Engine Oil
(a)
Start the engine to increase the temperature, then turn off the
engine. Remove oil drain plug (C) from the bottom of the
crankcase and clean with a cloth.
(b)
Drain engine oil into a container.
(c)
Replace the drain plug (C) If Oil Filter is not being replaced, fill the
engine with the correct quantity and grade of oil through the filler.
Change Engine Oil Filter
(a)
Remove the oil filter cartridge (D).
(b)
Let the engine oil flow into a container.
(c)
Clean area on the crankcase.
(d)
Apply a thin layer of oil to cartridge gasket before you
install the filter.
(e)
Only use your hand to tighten the filter cartridge (D).
(f)
Check for oil leaks around the cartridge gasket after the
engine is started.
(g)
Fill the engine with the correct quantity and grade of oil
through the filler.
CAUTION
Allow Engine oil to cool sufficiently before attempting work. Hot Oil can cause Severe Burns. Engine oil can
cause damage to your skin. Use gloves. If engine oil touches your skin,
clean the area immediately.
CAUTION
Discard engine oil as recommended by local authorities.
D
!
!
A
B
Summary of Contents for MT503
