Ransomes MT503, Safety, Operation & Maintenance Manual/Parts List

Page: 51 / 132

en-51
CONTROLS 6
6.5.12 INCLINOMETER _____________________________________________________
Using the PIN Menu Buttons 2 and 3 to arrow up and down , and
Button 4 to select Inclinometer and this gives you the option to Enable or
Disable TST™.
Note: If TST™ is installed, but disabled via the screen, the machine angle
when greater than 14° will be displayed, however no alarms or physical
interventions will occur.
If TST™ is not installed then Not Installed will be displayed on this screen
and the Disabled and Enabled options will be greyed out.
6.5.13 RESET DEFAULT PARAMETERS _______________________________________
The machine will have factory set
defaults. You can reset to factory
settings by Using the PIN Menu
Buttons 2 and 3 to arrow up and
down , and Button 4 to select Set
Default Parameters. Press arrow to
confirm.
6.5.14 DISPLAY INCLINES __________________________________________________
Only Visible if TST™ is installed and
enabled showing machine angle.
Left/Right, Forward Backwards.
Rotating graphics to illustrate
direction. With a central value
underneath each picture to show
magnitude of angle.
To access this screen go to Main
Menu, Service Menu, Display
Inclines then Button 4 .
Inclinometer
Disabled
Enabled
Not Installed
Set Default Parameters
Press To Confirm Set
To Default Parameter Values
Set Default Parameters
Press To Confirm Set
To Default Parameter Values
Are You Sure?
Yes No
0º 0º
Display Inclines
45º 45º
Display Inclines