Ransomes MT503, Safety, Operation & Maintenance Manual/Parts List

Page: 104 / 132

en-104
9 ADJUSTMENTS
9.6 CYLINDER HEIGHT OF CUT ADJUSTMENT ____________________________
TO ADJUST:
1. Turn adjuster (A) at the rear of the unit
clockwise to reduce the height of cut, or
anticlockwise to increase the height of cut
alternately. The grooves
(B) are used as an
rough indicator for setting the roll parallel.
9.6.1 FLAIL UNIT HEIGHT OF CUT ADJUSTMENT __________________________
TO ADJUST:
1. Turn adjuster (A) at the rear of the unit
clockwise to reduce the height of cut, or
anticlockwise to increase the height of
cut alternately. The grooves
(B) are
used as an rough indicator for setting
the roll parallel.
2. The Height of Cut decal
gives approximate height of
cut. This will vary
depending on the amount
of wear and condition of the
flail blades.
A
B
A
B
10029876
B
C
D
E
F
G
H
A
A 20mm 0.8 inch
B 26mm 1 inch
C 32mm 1.26 inch
D 38mm 1.5 inch
E 44mm 1.7 inch
F 50mm 2 inch
G 56mm 2.2 inch
H 62mm 2.4 inch
HOC