Rankam ST1017-012939, Operator'S Manual

Page: 3 / 24

P 3
Grill Installation Codes
The installation and pressure regulator must conform with local codes, or in the absence of local
codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA 54 , or the Natural Gas and Propane
Installation Code, CSA B149.1 , as applicable, including:
1. The appliance and its individual shutoff valve must be disconnected from the gas supply
piping system during any pressure testing of that system at test pressures in excess of 1/2
psi (3.5 kPa).
2. The appliance must be isolated from the gas supply piping system by closing its individual
manual shutoff valve during any pressure testing of the gas supply piping system at test
pressures equal to or less than 1/2 psi (3.5 kPa).
Casters Installation Code
The installation shall be made with a connector that complies with the Standard for Connectors
for Movable Gas Appliances, ANSI Z21.69-CSA6.16, and a quick disconnect device that
complies with Standard fro Quick –Disconnect Devices for Use With Gas Fuel,
ANSIZ21.41.CSA6.9.
To expedite the assembly processes follow these general guidelines:
Tools required for Assembly:
1. Protective work gloved
2. Protective eyewear
3. Phillips Head Screwdriver
You will need assistance from another person to handle the grill head and other large, heavy
parts.
Open Lid of shipping carton and remove top sheet of cardboard and / or packing materials. Lay
cardboard sheet on floor and use as a work surface to protect floor and grill parts from
scratches.
You may slice the carton front corners with a utility knife to lay open the carton front panel. This
allows you to raise the grill head Lid and remove the components packed inside, making it
easier to lift.
Use of Hardware and Part Diagrams to ensure all items are included and free of damage.
NOTE: This gas grill is designed to be used with two 20lb LP Gas tanks (not included) for 8
burner operation. A tank placed on the right will operate the four right-side burners. A tank
placed on the left will operate the four left-side burners.
Hardware list
No Description Qty Diagram
#1 Phillips Head Screws
1/4” x 15mm 16
#2 Phillips Head Screws
1/4” x 12mm 16
#3 Thumbscrew
1/4” x 13mm 4
#4 Phillips Head Screws
3
/
16
” x
8
mm
4
#5 Washer
Ø18 x Ø7 x 1mm 4