EcoPro300
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
39.) Mount the tongue jack and tighten the bolts.
The manual log roller arm mounts in this position.
40.) Remove the cotter pin and slide out the pin & roller.
41.) Line up the tab holes and re-insert the pin and roller
42.) re-insert cotter pin and bend the end of the cotter pin so it stays in
place.
43.) Place the end of the log holder spring in the hole of the log holder and
tighten bolt.
44.) Remove 18mm bolts & 19mm nuts from side of processor.
45.) Assemble wedge adjuster as shown.
46.) The nut goes on a few threads, once everything is in position you can
tighten this to adjust the tension of the wedge adjuster to where you
prefer it.
