EcoPro300
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
97.) Add fuel to engine fuel tank, do not fill above red level marker in tank
neck, the tank vents through the cap, if fuel is above this line engine will
not run very well and will stall. Premium fuel is recommended, Farm Fuel
should not be used.
98.) The emergency stop button is pushed down to stop the engine so make
sure it is in the run position, turn it slightly and the button will pop up if it
is in the off position.
99.) Make sure that manual ram engagement bar is in up position, Start
engine and let idle until engine and hydraulic oil are at operating
temperature
100.) This valve is used to control the flow to the conveyor, you can control
the speed or shut it right off, for cold starts this valve should be closed
until the hydraulic oil is warm and then opened to allow the conveyor to run
run.
101.) While engine is warming up, adjust conveyor belt to run in center of
upper and lower pulleys, upper puller has bolts on either side for
adjustment, lower puller has this bolt, slightly loosen the 2 bearing nuts and
bolts and use this bolt to adjust the position then tighten bearing bolts.
When adjusted properly belt rides in center of lower pulley
102.) When unit is up to operating temperature operate saw and ram
multiple times to make sure they are adjusted and working properly
103.) Shut unit off
104.) Check all nuts, bolts, hose and fittings one more time, check for
leaks
