Preparing for use
R&S
®
QAR50
16
User Manual 1179.4992.02 ─ 02
To tilt the R&S
QAR50, you can attach a suitable aid like a handle to the mounting
holes not needed for the feet. While tilting the R&S
QAR50, be careful not to dam-
age the R&S
QAR50 or the supporting feet. One person must secure the
R&S
QAR50 while another person tilts the R&S
QAR50.
For the lying position, proceed as follows to attach the supporting feet.
a) Tilt the R&S
QAR50 by 90° to an upright position (make sure that the side with
the connector board is on the bottom).
Figure 4-5: Tilting the R&S
QAR50 into an upright position
b) Screw the two feet to the mounting holes indicated in
wrench. The screws and wrench are part of the delivery (M8X45).
Put the washers between screw heads and feet.
Figure 4-6: Attaching the supporting feet for lying position
c) Screw in the caps of the mounting holes (M8X16 screws). The caps are part of
the delivery.
Installing the R&S
QAR50
