Remote commands to perform measurements in MSRA mode
R&S
®
FSWP-B1
94
User Manual 1177.5862.02 ─ 09
OUTPut<up>:TRIGger<tp>:PULSe:LENGth
<Length>
This command defines the length of the pulse generated at the trigger output.
Suffix:
<up>
.
1..n
<tp>
Selects the trigger port to which the output is sent.
2 = trigger port 2 (rear)
Parameters:
<Length>
Pulse length in seconds.
Default unit: S
Example:
OUTP:TRIG2:PULS:LENG 0.02
Manual operation:
See
9.4.3
Configuring data acquisition
The following commands are required to configure the actual data acquisition.
Configuring data acquisition is only possible for the MSRA primary channel. In MSRA
secondary application channels, these commands define the analysis interval (see
Chapter 9.9, "Commands specific to MSRA secondary applications"
sure to select the correct measurement channel before executing these commands.
...............................................................................................94
........................................................................................ 95
...............................................................................................95
.....................................................................................96
................................................................................... 96
........................................................................................ 97
...............................................................................................99
.............................................................................................99
[SENSe:]IQ:BWIDth:MODE
<Mode>
This command defines how the resolution bandwidth is determined.
Parameters:
<Mode>
AUTO | MANual | FFT
AUTO
(Default) The RBW is determined automatically depending on
the sample rate and record length.
Configuring MSRA measurements