Remote commands to perform measurements in MSRA mode
R&S
®
FSWP-B1
107
User Manual 1177.5862.02 ─ 09
Suffix:
<n>
.
Example:
SWE:POIN 251
Manual operation:
See
[SENSe:]SWEep:TIME
<Time>
This command defines the measurement time. It automatically decouples the time from
any other settings.
Parameters:
<Time>
refer to data sheet
*RST:
depends on current settings (determined automati-
cally)
Default unit: S
Manual operation:
See
SYSTem:SEQuencer
<State>
This command turns the Sequencer on and off. The Sequencer must be active before
any other Sequencer commands (
INIT:SEQ...
) are executed, otherwise an error
occurs.
A detailed programming example is provided in the "Operating Modes" chapter in the
R&S
FSWP User Manual.
Parameters:
<State>
ON | OFF | 0 | 1
ON | 1
The Sequencer is activated and a sequential measurement is
started immediately.
OFF | 0
The Sequencer is deactivated. Any running sequential measure-
ments are stopped. Further Sequencer commands
(
INIT:SEQ...
) are not available.
*RST:
0
Example:
SYST:SEQ ON
Activates the Sequencer.
INIT:SEQ:MODE SING
Sets single Sequencer mode so each active measurement is
performed once.
INIT:SEQ:IMM
Starts the sequential measurements.
SYST:SEQ OFF
Manual operation:
See
Capturing data and performing sweeps