Page
7
of
24
RAD0172
R&G Racing
Unit
1, Shelley’s
Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
•
On the right side of the bike, the radiator guard mounts should align roughly with the mounting
holes on the side of the radiator. Offer the plastic radiator surround back into position ensuring the
side mounts sit over the top of the radiator guard mounts, before refitting the OEM bolts through
the plastic surround, then through the radiator guard mounts and tighten into the radiator, as
shown in
(pictures 10 & 11)
.
•
On the left side of the bike, remove the previously fitted loose bolt, allow the plastic surround to sit
back against the radiator, ensure all the holes align and re-fit the two OEM bolts through the
radiator surround, then through the radiator guard and tighten into the side of the radiator, as
shown in
(picture 12)
.
•
Re-fit the OEM bolt that secures the centre of the radiator guard in place under the headstock,
before checking the radiator guard and surround are correctly mounted and tighten all five bolts.
•
Re-fit the radiator plastic cowls on both sides of the bike and tighten the three bolts on both sides.
•
Re-fit the rubber cover onto the radiator filler neck before re-fitting the radiator filler cap.
If fitting to the Ducati Supersport 950 + S 2021- (item 4 and 5 required)
•
The radiator surrounds or fairing will need to be removed to access the radiator mount holes on
either side of the radiator as shown in
(picture 15)
.
•
To remove the fairing and radiator surround,
•
Remove the 1 x bolt from the right-hand side of the radiator as arrowed in
(picture 19)
.
•
Loosen off 1 x bolt as arrowed in
(picture 20)
to allow the horn mount to pivot.
•
Remove the 1 x bolt from the left-hand side of the radiator as arrowed in
(picture 21)
.
•
Offer the radiator guard up to the radiator and align the mounting holes with the bolt holes.
•
Replace the OEM bolts along with the provided 2 x bolts and washers
(items 4 and 5)
into the 2
lower mounting points on both sides of the radiator as circled in
(pictures 20 and 21)
.
•
Make sure the retaining bolts are fully tightened before reassembling any radiator surrounds or
fairing.
•
Check the tightness of all bolts and that all panels are secure before riding.
If fitting to the Ducati Diavel 1260S 2019-2020
•
Remove the indicator side panels as per previous instructions, cutting the cable ties tidying the
indicator wiring in order to free the panels, as shown in
(picture 13)
.
•
Secure the radiator guard to the radiator using 4 of the included cable ties, as shown in
(picture
14)
.
•
Refit the side panels and re-tidy the indicator wiring using the 4 remaining cable ties.
•
Check the tightness of all bolts and that all panels are secure before riding.
