Page
6
of
24
RAD0172
R&G Racing
Unit
1, Shelley’s
Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Picture 21
FITTING INSTRUCTIONS
If fitting to the Ducati Hypermotard 950 2019-, Monster 1200 + 821 2014-, Supersport
2017-
•
To fit the radiator guard to the bike cut the foam strip provided into 10mm wide pieces and stick
them to the back of the radiator guard frame, so that they sit between the radiator guard and the
radiator.
•
Remove the three 4mm A/F bolts on the right side of the bike that secure the plastic cowl in place
on the back of the radiator, as shown in
(picture 1)
.
•
Remove the plastic cowl from the radiator, as shown in
(picture 2)
.
•
On the left side of the bike, remove the radiator cap and pull the rubber cover over the neck of the
radiator filler, as shown in
(pictures 3 & 4)
.
•
Remove the three 4mm A/F bolts that secure the plastic cowl in place on the back of the radiator,
as shown in
(picture 5)
.
•
This plastic cowl cannot be fully removed from the bike, just pulled clear to gain access to the two
side bolts on the radiator, as shown in
(picture 6)
.
•
Remove the two bolts on both sides of the radiator that secure the plastic radiator surround to the
radiator, as shown in
(pictures 6 & 7)
.
•
Remove the remaining bolt that secures the plastic radiator surround in place that is located under
the headstock, as shown in
(picture 8)
, before removing the plastic surround from the bike.
•
Offer the R&G Radiator Guard roughly into place and locate one of the OEM bolts through a
mounting hole on the left side of the bike and tighten a few turns in the side of the radiator as
shown in
(picture 9)
.
This is to hold the radiator guard loosely in place whilst fitting the plastic
surround onto the other side of the bike.
