R&G LP0192BK, Fitting Instructions Manual

Page: 9 / 16

LP0192
R&G Racing
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301 www.rg-racing.com Email: info@rg-racing.com
9
Page | 9

Gently unclip the plastic under-tray from the location tabs shown in pictures 11 and 12
and gently lower the under-tray (you will have to feed the tool kit bungee through the slot
in the rear sub-frame) until it rests on the rear wheel.

With the under-tray lowered remove the two screws arrowed in picture 13.

Carefully remove the wiring taking note of its routing.

Carefully remove the original licence plate bracket while feeding all the wires through the
holes in the under-tray.
If reusing the original indicators

Remove the two bolts arrowed in picture 14 and remove the licence plate bolt bracket.

Remove the nut arrowed in picture 15 and remove the reflector.

Remove the three bolts arrowed in picture 16, the bracket can now be carefully separated
into two halves.

Remove the screw arrowed in picture 17 and then the clamp plate and the spreader plate.

Then squeeze the rubber indicator stem to allow the indicator to be removed as shown in
picture 18.

Repeat the above to remove the other indicator (please note the relevant sides as they
have drain holes witch should point downwards on assembly).

Fit the indicators to the indicator/licence plate mounting bracket (item 21) as shown in
pictures 19, 20, 21 and 22 in the same manner as they were mounted originally (ensure
they are fitted on the correct sides).
If using Mini indicators

If using mini’s fit the indicators of choice to the indicator/licence plate mounting bracket
(item 21) (R&G mini indicator product code RG370 for bulb type and RG371 for LED
type or RG372 for Aero Style led type) using the four indicator adaptors (item 2) (please
use the provided heat shrink (item 15) to protect the wiring) as shown in the pictures
below.

Fit the new licence plate illuminator (item 18) to the new licence plate bracket (item 21)
as shown in pictures 23 and 24 (please use the provided heat shrink (item 15) to protect
the wiring).

PLEASE NOTE YOU WILL NEED TO GLUE THE LIGHT SHROUD TO THE
LED LICENCE PLATE ILLUMINATOR USING SUPER GLUE.

Use the cable ties and clips (items 3 and 14) to neaten and tidy the wiring as shown in
picture 25 ensuring to leave room around the slot for bolts and washers when fully
assembled.

Stick the self-adhesive neoprene foam (item 16) to the main mounting bracket (item 1) as
shown in picture 26.