Page
9
of
23
LP0300BK
R&G
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
If using OEM indicators:
If you are re-using the original indicators these will need to be removed from the original licence
plate unit following the steps here, if using Mini indicators, skip this section.
•
Begin by locating and removing the six Allen head bolts found on the underside of the OEM licence
plate unit as shown in
pictures 14 and 15
.
•
Remove the three bolts located on the under-side of the original bracket as shown in
picture 16
.
•
After removing the fasteners detailed in the previous steps, the tail unit should easily come apart.
•
Locate and remove the indicator securing bolt from the inside of the licence plate unit using an
8mm spanner as shown in
picture 17
.
•
Remove the securing plate on the back of the indicator as shown in
picture 18
and put to one
side for use later.
•
Remove the indicator.
•
The indicator mounting rubber can now be carefully pulled out of the tail unit by squeezing the
rubber to release it from the mount as shown in
picture 19
.
•
Repeat the above to remove the opposite indicator.
•
In the opposite order from the removal, ensuring the LHS and RHS indicators are placed on the
correct side, place each indicator rubber through the correct mounts on the R&G tail bracket
(
Item
1
) as shown in
pictures 19 and 20
then repeat for the opposite indicator.
•
Each indicator will need an indicator spacer (
item 7
) to secure the rubber, feed each spacer over
the wire and feed indicator rubber through the spacer so it locates against the R&G tail bracket
as arrowed in
picture 21
.
•
Reassemble the indicator securing plate in the same way it was removed and fix in place with the
OEM 8mm hex bolt as shown in
pictures 21 and 22
.
•
Proceed to Licence plate illuminator fitting section.
If using R&G Mini indicators:
NOTE: 1 x set of RGR0002 resistors (available separately) may be required to achieve the correct flash
rate.
•
Put the tail unit to one side and make sure it is stored safely so the bike can be returned to
standard if desired.
•
To assemble your R&G tail tidy with mini indicators, you will need to use the indicator adapter
plates (
item 6
) included with the kit. Thread one spacer over the indicator wire with the larger
surface against the indicator body as shown in
picture 23
.
•
Thread the wire and indicator spacer through one indicator mount on the tail bracket as shown in
picture 24
. Thread the second indicator adapter plate (
item 6
) over the exposed wire followed
by the indicator nut as shown in
picture 25
so both raised plastic bosses sit into the tail bracket
as shown in
pictures 24 and 26
and secure in place using the locking nut provided with the
indicator. DO NOT overtighten.
•
Thread one indicator wiring cover (
item 8
) over each pair of indicator wires (a small amount of
lubricant or washing up liquid will help with this) as shown in
picture 27
.
•
Fit one length of heat shrink (
Item 11
) over each pair of indicator wires and heat with a hot air
gun or hair dryer to neatly hold the wiring covers in place and protect the wires as shown in
picture 28
.
•
Connect 2 x CON0009 (
item 9
) connectors to the corresponding wires of the R&G mini indicators
using the following colour code:
o
Black
–
Black
o
Yellow
–
Black
