Page
8
of
23
LP0300BK
R&G
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
PICTURE 27
PICTURE 28
PICTURE 29
PICTURE 30
FITTING INSTRUCTIONS
•
Remove the pillion seat, using the lock under the tail for the passenger seat (arrowed in
picture
1
). Then using a 5mm Allen key, remove the 2 rider seat bolts as shown in
picture 2
.
•
Locate the OEM indicator and licence plate illuminator connectors under the rider seat. These
come in a block and can be disconnected using a small flat bladed screwdriver to lift the plastic
tab to disconnect the 3 connections arrowed in
picture 3
.
•
Remove the plastic screw rivet arrowed in
picture 4
.
•
Remove the two bolts arrowed in
pictures 5 and 6
.
•
Carefully remove the left-hand side seat cowl as shown in
picture 7
.
•
Loosen but do not remove the two bolts arrowed in
picture 8
.
•
Remove the plastic screw rivet arrowed in
picture 9
.
•
Remove the two bolts arrowed in
pictures 10 and 11
.
•
Carefully remove the right-hand side seat cowl as shown in
picture 12
.
•
Remove the four bolts arrowed in
pictures 13 and 8
then carefully lower this away from the bike
while feeding the 3 disconnected wires through the plastic openings of the tail unit taking note of
the wiring route.
