Instruction Manual – Ramsond CUT series plasma cutters Rev 10-0993
© Copyright Ramsond Corporation. All rights protected. Unauthorized reproduction prohibited.
Page 9
3.4 - AIR REGULATOR / FILTER
Air regulator/filter adjusts the air pressure to the plasma torch. It also acts as a filter and removes moisture
from compressed air. The air regulator attaches to the rear of the unit. From the compressor the air is
connected to the regulator. From the regulator a tube will connect to the GAS IN nozzle in the rear of the
unit which supplies the air to the plasma torch. The L shaped QUICK-RELEASE Nozzle also connects to
the middle position of the air regulator. The orange tube connects to this QUICK RELEASE ‘L’ NOZZLE.
The orange tube is connected to the pressure gauge located in the front panel. The adjustment knob on
top of the regulator adjusts the air pressure. Lift and turn this knob to adjust the air pressure.
Moisture from the compressed air is filtered and collected in the glass bowl and can be drained by pulling
the WATER DRAIN RELEASE.
CAUTION
TURN THE UNIT OFF BEFORE DRAINING THE WATER AS THE DRAINED WATER MAY GET SUCKED
INSIDE THE UNIT BY THE TURNING FAN.
IMPORTANT
WHEN INSTALLING REGULATOR FITTINGS FOLLOW THE ARROW ON THE REGULATOR FOR AIR
FLOW DIRECTION. FAILURE TO INSTALL FITTINGS IN PROPER DIRECTION WILL SUBSTANTIALLY
AFFECT PLASMA CUTTER PERFORMANCE.
