4. Attach the hook to the outboard tether strap loop (see diagram). Tighten the tether
strap according to the child seat manufacturer’s instructions.
Installing Three Child Restraints:
1. Place a child restraint on each outboard rear seat. Route the tether straps following
the directions for right and left seating positions, above.
2. Attach both hooks to the center tether strap loop, but do not tighten the straps yet.
3. Place a child restraint on the center rear seat. Route the tether strap following the
directions for the center seating position, above.
4. Attach the hook to the outboard tether strap loop.
5. Tighten the tether straps according to the child seat manufacturer’s instructions,
tightening the right and left tether straps before the center tether strap.
WARNING!
• An incorrectly anchored tether strap could lead to increased head motion and
possible injury to the child. Use only the anchorage position directly behind the
child seat to secure a child restraint top tether strap.
• If your vehicle is equipped with a split rear seat, make sure the tether strap does
not slip into the opening between the seatbacks as you remove slack in the strap.
Tether Strap Through Center Tether Strap Loop
And Attached To Outboard Tether Strap Loop
Left Outboard And Center Seating Position Shown
G E T T I N G S T A R T E D
57
Summary of Contents for CHASSIS CAB 3500 2017
Page 271: ...NOTES 269...
Page 272: ...NOTES 270...
Page 273: ...NOTES 271...
Page 274: ...NOTES 272...
