RAM CHASSIS CAB 3500 2017, User Manual

Page: 161 / 276

NOTE:
You have 30 seconds in which to initiate the next step after the LEARN button has
been pushed.
6. Return to the vehicle and push the programmed HomeLink button twice (holding
the button for two seconds each time). The instrument cluster display will show
“CHANNEL # TRANSMIT”. If the garage door opener/device activates, program-
ming is complete.
NOTE:
If the device does not activate, push the button a third time (for two seconds) to
complete the training.
7. To program the remaining two HomeLink buttons, repeat each step for each
remaining button. DO NOT erase the channels.
Programming A Non-Rolling Code
NOTE:
For programming Garage Door Openers manufactured before 1995:
1. Turn the ignition switch to the ON/RUN position.
For vehicle’s equipped with Keyless Enter-N-Go, place the ignition in the RUN
position with the Engine ON.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink
button you wish to program while keeping the HomeLink indicator light in view.
3. Simultaneously push and hold both the HomeLink button you want to program
and the hand-held transmitter button.
4. Continue to hold both buttons until the instrument cluster display changes from
“CHANNEL # TRAINING” to “CHANNEL # TRAINED”, then release both buttons.
5. Push and hold the programmed HomeLink button and observe the indicator light.
NOTE:
If the instrument cluster display displays “DID NOT TRAIN” repeat from Step 2.
• To program the two remaining HomeLink buttons, repeat each step for each
remaining button. DO NOT erase the channels.
E L E C T R O N I C S
159