320
SERVICING AND MAINTENANCE
NOTE:
There are access covers over both headlamp
bulb access holes in the quad front lamp unit
housing (if equipped). These covers MUST be
reinstalled after the bulb has been replaced.
Fog Lamps — If Equipped
See below steps to replace.
1. Reach under and behind the front fascia/
bumper to access the back of the front fog
lamp housing.
2. Disconnect the fog lamp wiring harness
connector from the fog lamp bulb.
Fog Lamp Bulb
3. Rotate the bulb counterclockwise a quarter
turn to unlock the bulb from the housing.
4. Pull the bulb straight out from the housing.
Rear Tail / Stop, Turn Signal And Backup
Lamps
See below steps to replace.
1. Remove the two screws that pass through
the bed sheet metal.
Tail Lamp Screw Locations
2. Pull the outboard side of the lamp rearward
far enough to unsnap the two receptacles
on the outboard side of the lamp housing
from the two plastic snap post retainers in
the outer box side panel.
Pulling Out The Tail Lamp
3. Disconnect the wiring harness connectors
from the bulb socket.
CAUTION!
Do not contaminate the bulb glass by
touching it with your fingers or by allowing it
to contact other oily surfaces. Shortened bulb
life will result.
21_DS_OM_EN_USC_t.book Page 320
