Raleigh Audio Standard Extreme RAKK dac Mark III, Assembly Manual

Page: 8 / 65

Pre ­ assemble Standard (single input) I2S Adapter with the RAKK dac
————————————————————————————
Skip this section if you do not have a Standard (single input) I2S Adapter.
————————————————————————————
Wire the I2S Output on the I2S Adapter
1. Mount four 1” standoffs on the bottom of the I2S Adapter and secure with 6-32 screws.
2. Insert a ⅜ ” 6-32 setscrew about half-way into each 1” standoff.
3.
Install a ⅜ ” standoff as a nut on each of the four 1” standoffs.
4. Cut three pieces of #22 black wire, each 1 ⅜ ” long.
1 ⅜ ” is the length of the two standoffs, which may be used as a gauge.
5. Cut three pieces of #22 violet wire, each 1 ⅜ ” long.
6. Strip ¼” of insulation from each end of the wires and tin the ends by melting a little solder
onto the stripped ends.
7. Insert the three black wires from the bottom of the board into the following three locations:
•
DATA -
•
LRCK -
•
BCK -
8. Solder and trim the leads.
7